State / Province
Application Information - General
Briefly describe your application
Battery Chemistry (Rechargeable):
Battery Chemistry (Primary):
Standard Cell Size
Pack Cell Configuration:
Cells in Series
Cells in Parallel
Pack Dimensions (Inches):
Pack Dimensions Entered Are
Note: These dimensions represent the working area of the pack that HOB can design to. This total volume includes the cells, circuit board(s), insulators, shrink wrap and wiring as a minimum. Allow for adequate space in your device side battery compartment design to ensure proper fit.
Application Information - Electrical
Note: System UV Cutoff should be set above protection circuit UV shutoff threshold.
Pack Options (Select all that apply):
If a fuel gauge is required, indicate form:
If Charger is External, list manufacturer and part number of stand alone charger or host side IC used:
Note: If you are planning on using an external stand-alone charger, at HOB's discretion, you may be requested to provide said charger for verification of compatibility with the designed pack electronics. If your charger is an IC on the host side of your device, we may request a working circuit or schematic.
Briefly describe your application load (Resistive, Capacitive, Inductive):
Note: The host system's load profile is important in determining the optimal circuit trip points to ensure optimal battery safety. In particular, it is critical to know if the battery pack will experience any inrush current due to system startup or power switchover events. If no load profile is provided prior to the design phase, there may additional NRE costs incurred to properly characterize the safety parameter settings during the validation stage.
Briefly describe any special termination requirements. List manufacturer & part number(s) if applicable:
Application Information - Regulatory
Required Regulatory / Certification Tests:
Note: UN38.3 testing is required for all multiple cell Lithium packs. Please contact HOB for further information.